![]() Faster speeds will obviously get the job done quickly, but some people advise that you keep it lower (not too low) for a better burn. ![]() Now below the Information box, in the Write Speed setting, choose what speed you want to burn at. Those are the speeds at which you can burn with the combination of your burner and the blank disc that you have chosen. Take note of the "Supported Write Speeds". Now in the Information section of the program, you will see a lot of new information come up. Going over 4.36GB will require a dual layer DVD). ImgBurn - Write Speed Put in a blank CD or DVD (DVD will be required for over 700MB, but that doesn't mean you have to choose a CD for less than 700MB either. Like shown above, you should now see your ISO(s). Now navigate to the folder with the image in it that you would like to burn. Click the first one (magnifying glass) and a File Browser, like the one shown above, will pop up (will look different under Vista). One has a magnifying glass over it, and the other has a +. ImgBurn - Open ISO In the Source section of ImgBurn, you will notice two small folder icons. ![]() The first thing we need to do however is open the ISO we want to burn. Pay particular attention to "Supported Write Speed" after you put in a blank, as you will need to set this in the Settings section just below this box. On the right hand side of the program is one box of information on DVD/CD media you have in your drive. Make sure your correct DVD burner is selected here. Below the Source section is the Destination settings (and the Start button). Here is where you select the ISO file you want to burn and see information on it. The main window shown above is split into different sections. ImgBurn Interface ImgBurn is a pretty simple application. The option we are looking for is in the top left: "Write image file to disc". You will get a start screen like the one shown above. Burn Image with ImgBurn Once you have installed ImgBurn on your computer, run it. When it is installed, run the program and follow the steps below. ImgBurn Required: We will be using ImgBurn in this guide to burn our DVD Image (ISO, BIN/CUE, MDS, NRG etc.) to a blank CD or DVD depending on the capacity.Äownload and install ImgBurn. It's a simple program to use beyond its first use, which you will see below. ImgBurn has a wide variety of image formats such as ISO, BIN/CUE, NRG, MDS etc. In this guide we will see how to use an excellent freeware burning tool called ImgBurn to burn CD and DVD images to blank discs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |